2005

SUPER STOCK CHANGES AND UPDATES

All drawings and verbiage within the plans will be updated to show all changes.

All new elevator bolts now sold by the All American are now silver or zinc coated. If you can’t purchase these locally you may use black elevator bolts also.

S-3 Weights: All non-adjustable weight bolts will be 3”x 5/16” elevator bolts. The adjustable weight bolts will 6”x‘5/16” carriage attached to the top of floorboard with 5/16” washer ant nut.

S-6 Prohibited Assembly: Add. J. Do not sand machine marking off the edge of the floorboard or bevel or round the edges of the floorboard.

SUPERSTOCK DIVISION ADJUSTMENT

2. Add, The 6”carriage weight bolt, nut and washers and wing nut supplied with the kit. Must be installed per plan.

13. Add (cannot be drilled).

STEP 1: FLOORBOARD

2. Add shim with a water base wood putty.

3. Delete sentence.

STEP 2:FLOORBOARD

2. Add, The foot brace new dimensions are 1 5/16” x 1 ½” x 3”.

5. Delete (Optional in existing cars)

STEP 5:MOUNTING STEERNG AND BRAKE

Figure 5.3A delete. Pg.10

Steering

1. Add, on the steering/brake assembly you may add 2 additional N washers to any or all of the 4 pulleys you may use in the setup of your steering. Remove reference to Fig. 5.3A

4.Fig. 6.5 and 6.5A&B are the only allowable options to running the steering cables.

Figure 6.4: Safety wire is no longer needed when using the two stop nuts on the steering turnbuckles.

Figure 6.5 A&B Are the only Optional Pulley Configurations.

Figure 6.6 plate shown in drawing is the steering/brake assembly. Also to be added to drawing is the wording, Two additional N washers may installed to raise any of the 4 pulleys on the steering/brake assembly.

STEP 8: WEIGHT

1. Add Carriage after 5/16”.